Install Print Gateway

Flash the ESP32-S3 Cloud POS Printer Gateway firmware from your browser. Uses Web Serial — Chrome or Edge on desktop required.

Firmware 0.2.1-p1
Target chip ESP32-S3 · USB native / UART bridge
Web Serial is not supported in this browser. Open this page in Chrome or Edge on a desktop computer.
  1. 1
    Connect the ESP32-S3 to USB. Prefer the native USB port for first install.
  2. 2
    Hold BOOT if needed, then click Connect & Install and pick the serial port.
  3. 3
    After install, release BOOT / press RESET. SoftAP ESP32-Printer-XXXX appears for WiFi setup, or open the device IP on LAN.
First install erases flash when prompted. WiFi / MQTT settings live in NVS and can be reconfigured from the device web UI after boot. Later updates on a live device can use LAN OTA at /update.

Configure over Serial

After flashing, set WiFi, MQTT and the printer directly over USB — no SoftAP or LAN needed. Uses Web Serial (Chrome / Edge desktop). Close the installer's serial dialog first, then connect here.

Disconnected
Web Serial is not supported in this browser. Use Chrome or Edge on a desktop computer. 
Not connected. Click "Connect serial" and pick the device port.
WiFi
MQTT (optional)
Printer (TCP)
Manual command